Disconnect engine wiring harness - AR01.00-P-2410-02VD

Fig 1: Identifying Engine Wiring Harness (1 Of 2)

Unclip electrical connectors (G3/3x1, G3/4x1, G3/5x1, G3/6x1) and electrical lines for O2 sensors out of retaining clamps.

Disconnect electrical connector (G3/3x1, G3/4x1, G3/5x1, G3/6x1) for O2 sensors.

Detach connector from backup lamp switch (S16/2).

Fig 2: Identifying Engine Wiring Harness (2 Of 2)

Release plug (3) and disconnect from the ME-SFI [ME] control unit (N3/10).

Disconnect electrical connectors (4, 5)

Loosen engine wiring harness and place aside.

Detach ground line (6) from longitudinal member.

Remove nut (7) and electrical line for circuit 30 (8) for battery (G1).

Loosen nut (9) and remove electrical line for circuit 30 (10) from battery (G1).

Detach sealing (11) from partition wall and lay engine wiring harness on cylinder head cover.