Removing/installing the fluid level sensor for the windshield washer system - AR82.35-P-6005V

MODELS 171.4 

Fig 1: Identifying Fluid Level Sensor For Windshield Washer System Components

Courtesy of MERCEDES-BENZ USA

	Remove/Install
1	Remove the rear fender liner in the right front fender		AR88.10-P-1300V
2	Disconnect electrical connector (1).
3	Using an assembly wedge, press the switch for the fluid level sensor for the windshield washer system (S42) away from the windshield washer fluid reservoir (2). Place the switch aside out of the away.	Collect washer fluid which flows out.
			Figure
		Installation:  Install a new gasket for the fluid level sensor for the windshield washer system (S42) in the windshield washer fluid reservoir (2).
4	Install in the reverse order
5	Fill washer fluid reservoir (2)
	Windshield washer system - inspect fluid level, adjust to correct level

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA