Remove/install front floor covering (left) - AR68.20-P-2050V

MODEL 171.4 

Fig 1: Identifying Left Floor Coverings, Luggage Net, Retaining Clip And Expansion Clip

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Left Floor Coverings And Accelerator Pedal

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Open Vario roof
2	Remove cover on center console		AR68.20-P-2350V
3.1	Remove HEAT control and operating unit	On vehicles without code (580) Automatic air conditioning and without code (581) Convenience automatic air conditioning	AR83.25-P-1125V
3.2	Remove AAC control and operating unit or comfort AAC control and operating unit	On vehicles with code (580) Automatic air conditioning or with code (581) Comfort automatic air conditioning	AR83.40-P-6350V
4	Remove upper control panel control unit.		AR54.21-P-1262V
5	Remove cover below left of instrument panel		AR68.10-P-1500V
6	Remove center console		AR68.20-P-2000V
7	Remove left front seat		AR91.10-P-1000V
8	Remove accelerator pedal (2)		AR30.12-P-1321V
9	Remove left door sill molding		AR68.30-P-4100V
10	Remove left floor covering in footwell		AR68.30-P-4010V
11	Remove expansion clip (3).	Installation:  Replace damaged expansion clips (3)
12	Unhook luggage net (4) from retaining clip (5)
13	Cut left floor covering (1) at marked separation points (arrows) with sharp knife	The separation points (arrows) are marked on the floor covering at the factory.
14	Remove left floor covering (1) from vehicle
15	Install in the reverse order