Remove/install clock spring contact - AR46.10-P-0200P

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 203 up to 30.6.02

Fig 1: Identifying Clock Spring Contact Remove/Install Component - Model 203 Up To 30.6.02

	Remove/install
1	Remove steering wheel	Front wheels in straight-ahead position.	AR46.10-P-0100P
2	Only unscrew the fastening screws (32h) until the fanfare horns and airbag clock spring contact (A45) can be removed	The fastening screws (32h) serve simultaneously as anti-twist protection or assembly aid.
3	Carefully remove the fanfare horns and airbag clock spring contact (A45) from the jacket tube	Installation: Push on the fanfare horns and airbag clock spring contact (A45) as far as the stop Installation: Do not use any oil or grease, otherwise malfunctions can occur. Installation: In order to avoid damage to the fanfare horns and airbag clock spring contact (A45) do not install these twisted. If the fanfare horns and airbag clock spring contact (A45) is not in the center position: ↓
		Set the clock spring contact to center position	AR46.10-P-0200-01I
	Check
4	Check fanfare horns and airbag clock spring contact (A45) for damage	Remove steering angle sensor (N49) for this step. Visual inspection, if necessary replace fanfare horns and airbag clock spring contact (A45)	AR46.10-P-0300P
5	Install in the reverse order