Lifting vehicle with pit lift or workshop jack - AR00.60-P-1000-01P

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.

Lifting up at the front

In order to avoid damage to the steering, under no circumstances should the vehicle be raised at the rear cross traverse

Position inspection pit lift or workshop jack at the jacking up sockets (1m) of the front cross traverse of the front axle carrier (1).
Raise vehicle.

Vehicles with 4MATIC

If the front engine compartment cover is mounted,

a flat cap for the assembly lift/vehicle jack must be used, or
a suitable base must be placed on the bent cap, otherwise the front engine compartment cover will be damaged.

Fig 1: Identifying Jacking Up Sockets And Front Axle Carrier

Raising vehicle at rear

Position inspection pit lift or workshop jack at the rear axle center assembly.
Raise vehicle.

Fig 2: Raising Vehicle At Rear