Remove/install bulbs of headlamp unit - AR82.10-P-1201V
MODELS 171.4 except CODE (614) Bi-xenon headlamp unit
Shown on the left front lamp unit (E1)
| Remove/install | ||
|---|---|---|
| The procedure for changing the bulbs for the standing lamps, turn signal lamps and high beams is described in the operator's manual | ||
| 1.1 | Turn the front wheels to the right as far as possible | Removing the left low beam (E1e2). |
| 1.2 | Turn the front wheels to the left as far as possible | When removing the right low beam (E2e2). |
| 2 | Remove the nut (1) and the screw (2) at the front part of the fender liner (3) | |
| 3 | Move the front section of the fender liner (3) downward until the left front headlamp unit (E1) or the right front headlamp unit (E2) can be accessed from the rear. | |
| 4 | Turn housing cover (4) to left and remove | |
| 5 | Turn bulb socket (5) to left and remove | |
| 6 | Remove the left low beam (E1e2) or right low beam (E2e2) from its bracket (5). When doing so, counterhold the bayonet ring (6). | Handle the glass bulb only with a soft, clean cloth. |
| 7 | Install in the reverse sequence | |
| 8 | Perform operational check |