Remove/install license plate lamps - AR82.10-P-5161R

MODEL 230.4 except CODE (P99) "AMG Black Series" special model 

Fig 1: Identifying License Plate Lamps Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove outer paneling at trunk lid		AR88.50-P-5080R
2	Undo screws (1) and remove side flaps drive gear (2) from trunk lid (3)	Remove side flaps drive gear (2) until the left license plate lamp (E19/1) or the right license plate lamp (E19/2) is accessible. Do not disconnect electrical connector from side flaps motor.
			*BA77.30-P-1007-01B
3	Undo nuts (5) and remove covering (6) from trunk lid (3)
4	Unclip left license plate lamp (E19/1) or right license plate lamp (E19/2) out of trunk lid (3)
5	Disconnect electrical connector (4) and remove left license plate lamp (E19/1) or right license plate lamp (E19/2)
6	Install in the reverse order