Fit illuminated door sill molding - AZ82.20-P-0001-01R

Model 230 

1. Drill 6 mm dia. hole at marked point (see arrow) through bead on frame floor system (FFS) and treat with corrosion protection agent.

   Do not damage carpeting in vehicle.

2. Secure connection cable for the lamp foil to the underside of the illuminated door sill molding (1) with adhesive tape (2) (see figure on left).
   Fig 1: Identifying Illuminated Door Sill Molding With Adhesive Tape

   Courtesy of MERCEDES-BENZ USA
3. Open connector housing (5) at connection wire of illuminated door sill molding and pull out wires.
4. Route connection lead for illuminated door sill molding (1) to passenger compartment through bore hole (see arrow) and insert into connector housing (5).

   Use clamps as required.

5. Clip in illuminated door sill molding (1).
   Fig 2: Identifying Illuminated Door Sill Molding And Connector Housing

   Courtesy of MERCEDES-BENZ USA