Remove/install instrument panel bottom section on driver side - AR68.10-P-1505R

MODEL 230.4 

Fig 1: Identifying Instrument Panel Bottom Section On Driver Side - Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Instrument Panel Bottom Section On Driver Side - Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Adjust driver seat to the rear
2	Loosen instrument cluster until bolts (2) are accessible.	Do not disconnect electrical connector from instrument cluster.	AR54.30-P-6015R
3	Remove bolts (2)
4	Unclip paneling (3) with mounting wedge		Figure
5	Unscrew bolt (4)
6	Remove transmitter key (A8/1) from EIS control unit (N73)
7	Unscrew rosette (9) from EIS control unit (N73) with claw-type wrench		Fig 4
8	Remove cover below instrument panel on left		AR68.10-P-1500R
9	Remove bolts (5)
10	Unclip cover (6) with mounting wedge		Figure
11	Unscrew bolt (7)
12	Remove rotary light switch		AR54.25-P-3250R
13	Unscrew bolt (8)
14	Remove instrument panel bottom section (1) downward	Pull EIS control unit (N73) out of instrument panel bottom section (1) toward rear Do not disconnect electrical connectors from EIS control unit (N73)
15	Install in the reverse order

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Claw-Type Wrench For Rosette On Ignition/Starter Switch (210 589 00 07 00)

Courtesy of MERCEDES-BENZ USA