Prepare window for installation - AR67.10-P-1000-03SX

The gluing area on the window must be absolutely free of dust and grease to prevent paint adhesion problem of the adhesive material when glazing.

1. Check window for scratches and damage, replace if necessary.

1. 2.1 Cut off residual adhesive material of window with scraper down to a height of approx. 2 mm. Remove residual adhesive material.

   When reinstalling removed window.

2. 2.2 Clean gluing area on window using cleaner in 1-component repair kit and rub dry with rag.

   When installing a new window.

3. 3.1 Repair damaged primer coat on window with primer included in 1-component repair kit.

   When reinstalling removed window.

4. 3.2 Coat gluing area on window with primer included in 1-component repair kit (max. width 20 mm).

   When installing a new window. Allow primer to flash off for at least 10 minutes. Windshields are generally delivered with a viewing window on the bottom left. If the viewing window is not required, coat this area on the inside of the window with primer.