Remove/install trim at C-pillar - AR68.30-P-4490SXS
MODEL 221.1 with CODE (Z07) Top protection
| Remove/install | |||
| Notes on avoiding damage to windows installed in special protection vehicles | AH67.00-P-0003-01FB | ||
| 1 | Fold down rear head restraints | ||
| 2 | Loosen edge guard (5) in area of upper C-pillar trim (2) and lower C-pillar trim (4). | ||
| 3 | Unclip and remove roller blind rail (1) from upper C-pillar trim (2). | ||
| 4 | Unclip cover (3) from upper C-pillar trim (2) and remove nut (6) | ||
| 5 | Remove bolts (9) on paneling on upper C-pillar (2) | ||
| 6 | Unclip and remove upper C-pillar trim (2) | ||
| 7 | Unclip clip (8) at lower C-pillar trim (4) | ||
| 8 | Remove nut (7) at lower C-pillar trim (4) | ||
| 9 | Remove rear seat cushion | AR91.12-P-1020SXS | |
| 10 | Remove bolt (12) at belt end fitting (10) | *BA91.40-P-1001-01O | |
| 11 | Remove lower C-pillar trim (4) while at the same time guiding seat belt (11) through it | ||
| 12 | Install in the reverse order |
SEAT BELTS/EMERGENCY TENSIONING RETRACTORS
| Number | Designation | Model 221 | |
|---|---|---|---|
| BA91.40-P-1001-01O | Bolt at belt end fitting | Nm | 32 |