LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2008 >> S450 >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Interior Equipment - General Information) >> Interior Equipment - General Information >> Notes on programming garage door opener transmitter unit - AH68.05-P-0002-01A

Notes on programming garage door opener transmitter unit - AH68.05-P-0002-01A

WARNING: This page does not describe the selected car, but rather 203 other vehicles, including the 2020 Mercedes-Benz SLC300, 2020 Mercedes-Benz SL550, 2020 Mercedes-Benz SL450, 2020 Mercedes-Benz S65 AMG, and 2020 Mercedes-Benz GLA250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL ALL with CODE 231 (Garage door opener) with CODE 232 (Garage door opener with frequency 284-390 MHz) 

IMPORTANT Details on programming garage door opener transmitter unit as well as the corresponding compatibility list are given on the internet site:

http://www.eurohomelink.com 

Programming in chapter "Current vehicles"

Programming the national version, learning in hand transmitter and synchronization of alternating code system is described in the Mercedes-Benz operating instructions.

Compatibility list in chapter "HomeLink compatibility".

Compatibility of garage door drive to garage door opener 

If the garage door drive is not compatible with the garage door opener, a universal receiver (Fix Kit receiver) can be installed in the garage for modulating the radio signal.

Additional information on universal receivers is available at the internet address http://www.eurohomelink.com  .

Misuse protection 

As of model series 204 the garage door opener transmitter unit with misuse protection is installed. It is necessary to perform an initial startup procedure for this garage door opener transmitter unit when replacing with STAR DIAGNOSIS. The safety code is initialized and the national version programmed.