Remove/install engine hood catch - AR88.40-P-3200SX
MODEL 216, 221
Illustrated on model 221
Shown on model 221 with code (551) Anti-theft alarm (ATA)
| Remove/install | |||
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. | Keep body parts and limbs well clear of moving parts. | AS00.00-Z-0011-01A | |
| 1 | Unscrew nuts (3) and remove engine hood catch upper section (2). | ||
| 2 | Unscrew bolts (4) on engine hood catch lower section (5) | ||
| 3 | Remove engine hood catch lower section (5) upward out of radiator crossmember and unhook engine hood cable (6) | ||
| 4.1 | Remove ATA [EDW] hood switch (S62) on right engine hood catch lower section (5) | On vehicles with code (551) Anti-theft alarm system ATA [EDW] | |
| 5 | Remove engine hood catch lower section (5) | ||
| 6 | Install in the reverse order | ||
| 7 | Check engine hood adjustment, adjust if necessary. | AR88.40-P-3020SX |