Remove/install retaining frame controls in instrument panel center section - AR68.10-P-1031GZ

MODEL 164 

Fig 1: Identifying Retaining Frame Controls In Instrument Panel Center Section Remove/Install Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
1	Switch off ignition and remove transmitter key from EIS [EZS] control unit	On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).
2	Remove center console		AR68.20-P-2000GZ
3	Remove radio		AR82.60-P-7502GZ
4.1	Remove lower control panel control unit (N72)	Only disconnect electrically. Only on model 164.8 or on vehicles with offroad package, code 430.	AR54.21-P-1263GZ
5	Remove AAC control and operating unit (N22).	Only disconnect electrically.	AR83.40-P-6350GZ
6	Remove upper control panel control unit (N72/1)	Only disconnect electrically.	AR54.21-P-1262GZ
7	Remove bolts (1)
8	Unscrew bolt (2)
9	Remove retaining frame controls (4).	Unclip clip (3).
10	Install in the reverse order