Remove/install fog lamp - AR82.10-P-5103GY

MODEL 164.8 

Fig 1: Identifying Foglamp Components Location

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
1	Switch off ignition and remove transmitter key from EIS control unit	On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m). Ensure that the light is switched off. The light switch must be in the "0" position.
2	Remove cover (1)	Long wedge	Fig 2
3	Unscrew bolt (2)
4	Remove left front fog lamp (E5/1) or right front fog lamp (E5/2) and disconnect electrical connector (3)
5	Install in the reverse order
6	Check front fog lamp settings, adjust if necessary
	Set or inspect fog lamps		AP82.10-P-8260-04GZ

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.