Replace coolant - AP20.00-P-2080GZD
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 Mercedes-Benz ML350, 2010 Mercedes-Benz ML350, 2009 Mercedes-Benz ML320, 2009 Mercedes-Benz GL320, and 2008 Mercedes-Benz ML320. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 642 in MODEL 164
| Checking | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury
to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant. |
Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. |
AS20.00-Z-0001-01A | |
| 1 | Unscrew cap (1) from expansion reservoir (2) for coolant and check coolant level Notes on coolant level | ||
| Notes on coolant level | AH20.00-P-1142-01GZB | ||
| Inspecting cooling system for leaks | AR20.00-P-1010GZB | ||
| If coolant level is too low: ↓ Check cooling system for leaks subject to a separate repair order. |
|||
| 2 | Drain coolant | AR20.00-P-1142GZB | |
| Notes on coolant | AH20.00-N-2080-01A | ||
| 3 | Pour in new coolant | AR20.00-P-1142GZB | |
| *BF20.00-P-1001-02W | |||
MIXTURE RATIO FOR COOLANT
| Number | Designation | ENGINE 642 in MODEL 164 | ||||
|---|---|---|---|---|---|---|
| BF20.00-P-1001-02W | Cooling system | Workshop replacement quantity | Liters | ≈6.5 | ||
| Antifreeze/water | Up to -37°C | 50/50 | ||||
| From -38 °C | 55/45 | |||||
| Specifications for service products | Sheet | BB00.40-P-0310-01A | ||||
| Sheet | BB00.40-P-0325-00A | |||||
| Sheet | BB00.40-P-0326-00A | |||||