Remove/install steering wheel - AR46.10-P-0100GZ
MODEL 164
Illustrated on model 164.1
| Remove/install | |||
|---|---|---|---|
| Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100°C. When working on these units, disconnect the power supply. | AS91.00-Z-0001-01A | |
| Risk of explosion caused by oxyhydrogen gas. Risk of poisoning and caustic burns caused by swallowing battery acid. Risk of injury caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries | No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and safety glasses. Only pour battery acid into suitable and appropriately marked containers. | AS54.10-Z-0001-01A | |
| 1 | Move steering wheel (1) to horizontal position. | ||
| 2 | Disconnect battery ground cable | AR54.10-P-0003GZ | |
| 3 | Remove driver airbag unit | AR91.60-P-0660GZ | |
| 4 | Separate electrical connector (5) | ||
| 5 | Detach wiring harness (3) from the bracket (2) | ||
| 6 | Remove countersunk screw (4); counterhold steering wheel (1) when doing so | ||
| *BA46.10-P-1001-02G | |||
| 7 | Remove steering wheel (1), in the process guide the wiring harness (3) through the opening in the steering wheel (1) | ||
| 8 | Clock spring contact for damage | ||
| Remove/install clock spring contact | AR46.10-P-0200GZ | ||
| 9 | Install in the reverse order | ||
| 10 | Conduct a road test | Turn signal reset If the steering wheel (1) is offset by more than one tooth, perfect turn signal indicator reset is no longer guaranteed. Airbag indicator lamp The SRS indicator lamp must not light up on full steering lock in both directions. Position of steering wheel (1) If the steering wheel (1) is crooked, adjust it by max. one tooth. |
STEERING WHEEL
| Number | Designation | Model 164.1/8 | |
|---|---|---|---|
| BA46.10-P-1001-02G | Bolts, steering wheel to steering shaft | Nm | 80 |