Remove/install rear-end door lining - AR72.20-P-3520GZ
MODEL 164
Shown on model 164.1
| Remove/install | |||
|---|---|---|---|
| Removal | Danger of breakage or tearing off plastic trim parts and associated mounting clips. | ||
| 1 | Unclip upper door lining paneling (1) from mounting clips (2) and remove | Mounting wedge | Figure |
| 2 | Remove screws (4) | ||
| 3 | Unclip side door lining paneling (3) and remove | Pull side door lining paneling (3) downward (arrow A) and pull out of rear-end door toward front (arrow B). | |
| Mounting wedge | Figure | ||
| 4 | Unclip bottom door lining paneling (5) | Start at right and left side with mounting clips (6), then unclip locking tabs (7). | |
| Mounting wedge | Figure | ||
| 5 | Disconnect electrical connector (8) and remove bottom door lining paneling downward (5). | ||
| 6 | Unclip rear-end door ambient light (E40/1) from center door lining paneling (9), disconnect electrical connector (11) and remove rear-end door ambient light (E40/1) | ||
| 7 | Unclip center door lining paneling (9) | Start unclipping at right and left side. Directly move mounting wedge to mounting clips (12). | |
| Mounting wedge | Figure | ||
| 8 | Remove center door lining paneling (9) | Installation: Replace mounting clips (12). | |
| 9 | Install in the reverse order |