Remove/install 12 Volt socket - AR54.10-P-1000RT

MODEL 164, 251 

Fig 1: Identifying 12 Volt Socket Remove/Install Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Illustrated on model 251 

	Remove/install
1	Fold up housing lid (2)	The interior socket (X58/1) is located in the trim (1) on the bottom right-hand side of the cockpit.
2	Use pliers to detach the interior socket (X58/1) from the housing (3) and pull out (arrow A)	Do not turn the interior socket (X58/1) when pulling out Installation:  Ensure that the two guides (arrows B) are inserted in the grooves of the housing (3). Slide in the interior socket (X58/1) until it latches in the housing (3) (arrow C).
		Pliers	Figure
3	Disconnect electrical connector (4)
4	Remove housing (3) from the trim (1)	Loosen the housing (3) at the two catch lugs (5) and pull out of the trim (1).
5	Install in the reverse order

Fig 2: Identifying Pliers (169 589 00 37 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.