Attaching Mercedes-Benz quick-clamping devices - AR40.20-P-0230GZ

MODEL 164 

Shown on model 164.1 

Fig 1: Identifying Five Mounting Holes In Rim

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Mercedes-Benz Quick-Clamping Devices

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Installing, removing
1	Attach quick-clamping devices to the front and rear wheels, remove clamping handles	The mounting bell is centered on the front wheel hub or rear axle shaft flange by locating the tracer pins in the five mounting holes (arrows) in the rim. Check quick-clamping devices, wheel mirrors and measurement sensors at regular intervals in accordance with the manufacturer's instructions.
		Quick clamping device	Fig 3
2	Attach wheel mirrors or measurement sensors
3	Remove in the reverse order

Fig 3: Identifying Quick-Clamping Device (124 589 01 31 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.