Notes on application of sealant to oil pan - AH01.45-P-0001-01AMG

WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 2012 Mercedes-Benz GL550, 2012 Mercedes-Benz GL450, 2011 Mercedes-Benz ML63, 2011 Mercedes-Benz ML550, and 2011 Mercedes-Benz ML350. However, it is still accessible from the selected car via links, so may be relevant.

Engine 156

Application off sealant to oil pan top section on an engine with a front sump

The line (1) identifies the sealant run

The sealing surface must be cleaned. The sealing compound must only be applied to the specified surface in the form of a bead and a height and width of 2.0 mm (±0.5 mm).

The sealing compound must be applied within 10 min.

The sealant bead must not be spread. Only the sealing compound listed in the Repair Products may be used.

Fig 1: Identifying Sealant Application Areas On Oil Pan Top Section On An Engine With Front Sump

Courtesy of MERCEDES-BENZ USA

Application off sealant to oil pan bottom section on an engine with a front sump

The line (1) identifies the sealant run

The sealing surface must be cleaned.

The sealing compound must only be applied to the specified surface in the form of a bead and a height and width of 2.0 mm (±0.5 mm).

The sealing compound must be applied within 10 min.

The sealant bead must not be spread. Only the sealing compound listed in the Repair Products may be used.

Fig 2: Identifying Sealant Application Areas On Oil Pan Bottom Section On An Engine With Front Sump

Courtesy of MERCEDES-BENZ USA

Application off sealant to oil pan top section on an engine with a rear sump

The line (1) identifies the sealant run

The sealing surface must be cleaned.

The sealing compound must only be applied to the specified surface in the form of a bead and a height and width of 2.0 mm (±0.5 mm).

The sealing compound must be applied within 10 min.

The sealant bead must not be spread. Only the sealing compound listed in the Repair Products may be used.

Fig 3: Identifying Sealant Application Areas On Oil Pan Top Section On An Engine With Rear Sump

Courtesy of MERCEDES-BENZ USA

Application of sealant to oil pan bottom section at rear for engine with rear sump

The line (1) identifies the sealant run

The sealing surface must be cleaned. The sealing compound must only be applied to the specified surface in the form of a bead and a height and width of 2.0 mm (± 0.5 mm).

The sealing compound must be applied within 10 min.

The sealant bead must not be spread. Only the sealing compound listed in the Repair Products may be used.

Fig 4: Identifying Sealant Application Areas On Oil Pan Bottom Section At Rear For Engine With Rear Sump

Courtesy of MERCEDES-BENZ USA

Application of sealant to oil pan bottom section at front for engine with rear sump

The line (1) identifies the sealant run

The sealing surface must be cleaned. The sealing compound must only be applied to the specified surface in the form of a bead and a height and width of 2.0 mm (±0.5 mm).

The sealing compound must be applied within 10 min.

The sealant bead must not be spread. Only the sealing compound listed in the Repair Products may be used.

Fig 5: Identifying Sealant Application Areas On Oil Pan Bottom Section At Front For Engine With Rear Sump

Courtesy of MERCEDES-BENZ USA