LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2008 >> GL320 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Engine Timing - 164 Chassis) >> Testing & Repair >> Check basic position of camshafts - AR05.20-P-6010 >> Check basic position of camshafts - AR05.20-P-6010AMG (ML63 AMG) >> Inspect basic position of camshaft - AR05.20-P-6010-01AMG

Inspect basic position of camshaft - AR05.20-P-6010-01AMG

WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 2012 Mercedes-Benz GL550, 2012 Mercedes-Benz GL450, 2011 Mercedes-Benz ML63, 2011 Mercedes-Benz ML550, and 2011 Mercedes-Benz ML350. However, it is still accessible from the selected car via links, so may be relevant.

Shown on the right cylinder head 

Fig 1: Identifying Retainer And Straightedge
G04958280Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  1. Turn engine at crankshaft in direction of engine rotation to a 40° crank angle after ignition TDC.

    IMPORTANT The 40° marking on the belt pulley must be aligned with the positioning edge on the timing case cover.

  2. Fix camshaft with straightedge to the rear side. The retaining device must allow itself to pushed over the camshaft afterwards.
scientia non olet · About LEMON Manuals