LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2008 >> GL320 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Lubrication, Oil Cooling - 164 Chassis) >> Testing & Repair >> Remove, install oil temperature regulator - AR18.30-P-3000AMG (ML63 AMG)

Remove, install oil temperature regulator - AR18.30-P-3000AMG (ML63 AMG)

WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 2012 Mercedes-Benz GL550, 2012 Mercedes-Benz GL450, 2011 Mercedes-Benz ML63, 2011 Mercedes-Benz ML550, and 2011 Mercedes-Benz ML350. However, it is still accessible from the selected car via links, so may be relevant.

ENGINE 156 

Fig 1: Identifying Oil Temperature Regulator Remove/Install Components
G04958546Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
REMOVINGINSTALLING Remove/install    
DANGER Risk of injury  caused by fingers being pinched or crushed  when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. Keep body parts and limbs well clear of moving parts. AS00.00-Z-0011-01A
DANGER Risk of death  caused by vehicle slipping or toppling off of the lifting platform. Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. AS00.00-Z-0010-01A
1 Remove timing case cover   AR01.40-P-8000AMG
2 Remove bolts (1)    
3 Take off cover (3) IMPORTANT The temperature regulator (2) is installed under pre-tension in the crankcase.  
4 Remove temperature regulator (2). IMPORTANTInstallation:  Replace sealing ring at cover (3).  
5 Install in the reverse order