Remove/install inside rearview mirror - AR68.40-P-0001GZ

MODEL 164 

Fig 1: Identifying Inside Rearview Mirror Remove/Install Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
1	Switch off ignition and remove transmitter key from EIS control unit	On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).
2	Remove front overhead control panel.	Do not disconnect electrically	AR82.20-P-1100GZ
3	Press catch (2) together from both sides
4	Pull inside rearview mirror (A67) downward
5.1	Disconnect electrical connector (1) from rain sensor (B38) and inside rearview mirror (A67)	If present.
6	Install in the reverse order