Separate outer rear center section - AR64.20-P-1000-01GZ

Fig 1: Identifying Spot Weld Milling Cutter (201 589 00 51 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1002-01A	Ball cutter, dia. 12 mm
WH58.30-Z-1006-01A	Vario Drill WS 91 spot weld removing tool
WH58.30-Z-1001-03A	Round wire brush, braided, dia. 70 mm
WH58.30-Z-1022-04A	Cutting disk, dia. 50 mm, 80 m/s (max. 30,600 rpm)

WORKSHOP EQUIPMENT

WE58.40-Z-1001-03A	Drill (electric/pneumatic)
WE58.40-Z-1002-03A	Straight grinder (electric/pneumatic)

1. Expose continuous welds and spot welds in areas A to D.
2. Separate continuous welds in areas A and B.
3. Cut out spot welds in areas C and D .

   Use spherical cutter in area D.

4. Remove rear outer center section (1).
   Fig 2: Identifying Rear Outer Center Section Spot Welds Areas A And B

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.