Legend of wiring diagram brake wear indicator - PE42.10-P-2000-60C
MODEL 463 with ENGINE 112.945 Right-hand steering
MODEL 463 with ENGINE 113.962 Right-hand steering
| Item | Designation | Coordinate |
|---|---|---|
| A1 | Instrument cluster | 18K |
| A1p13 | Multifunction display | 18K |
| E3 | Left taillamp | 14K |
| E3e4 | Stop lamp | 14K |
| E4 | Right taillamp | 16K |
| E4e4 | Stop lamp | 16K |
| E21 | Center high-mounted stop lamp | 10K |
| F1 | Fuse box | 3D |
| F1f10 | Fuse 10 | 3E |
| K40 | AIR pump relay | 11A |
| K40k5 | Differential lock relay | 11B |
| K66/3 | Electric soft top parking brake recognition relay | 27G |
| N26 | ATA [EDW] control module | 13K |
| N47-7 | ABS control module | 5A 15A 23A |
| R2/3 | Right heated windshield washer nozzle | 2G |
| S2/1 | Ignition/starter switch | 3A |
| S9/1 | Stop lamp switch (4-pin) | 8A |
| S10/1 | Left front brake pad contact sensor | 22K |
| S10/2 | Right front brake pad contact sensor | 20K |
| S10/4 | Right rear brake pad contact sensor | 25K |
| S12 | Parking brake switch | 28K |
| U7 | Valid for convertible | 27C |
| U54 | Valid for towing hitch | 8L |
| U142 | Not valid for Cabriolet | 29C |
| U181 | Valid for ATA < EDW > | 12L |
| U242 | Valid for disk brakes | 24L |
| W29/5 | Ground (left rear pillar) | 10G 14G |
| W29/6 | Ground (right rear pillar) | 16G |
| X20/3 | ASR/master brake cylinder connector (4-pin) | 27E |
| X33/11 | Brake lamp signal/CC [TPM] connector | 12G |
| X58 | Trailer hitch socket (13-pin) | 9K |
| X88/13 | Right front brake pad wear indicator contact sensor connector | 19F |
| X88/14 | Left front brake pad wear indicator contact sensor connector | 21F |
| X88/15 | Right rear brake pad contact sensor connector | 24H |
| X92/3 | Frame connector (22-pin) | 8H 24F |
| Z50/1 | Connector sleeve 1 | 5G |
| Z50/4 | Connector sleeve 4 | 13E |
| Z51/7 | CAN (High) 1 connector sleeve | 18F |
| Z51/8 | CAN (Low) 1 connector sleeve | 17F |
| Z51/9 | CAN (High) 2 connector sleeve | 18E |
| Z51/10 | CAN (Low) 2 connector sleeve | 17E |