Remove/install electrical contacts in equipotential bonding conductor - AR54.18-P-0101-01GR

Shown on the driver-side 

1. Pull out equipotential bonding (1) in driver footwell or front passenger footwell below the instrument panel on the cable network.
   Fig 1: Identifying Equipotential Bonding Conductor Remove/Install Components

   Courtesy of MERCEDES-BENZ USA
2. Push clip (2) on both sides outwards and remove fuse strip (3) in direction of arrow.
3. Pull out electrical connection (4) on equipotential bonding (1).
4. Install in the reverse order.

Fig 2: Identifying Equipotential Bonding, Clip, Fuse Strip And Electrical Connection

Courtesy of MERCEDES-BENZ USA