LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2008 >> E550 Base >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Wheels, Chassis Alignment Check -- Testing & Repair -- E550 (211.072) >> Testing & Repair >> Adjust rear-axle toe - AR40.20-P-0261T

Adjust rear-axle toe - AR40.20-P-0261T

MODEL 211.0 /2 /6, 219.3 

Fig 1: Identifying Tie Rod Components
G07506981Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
MODIFICATION NOTES

17.7.07 Overall toe-in at rear axle *BE40.20-P-1001-10E 
  Permitted difference between right and left side of vehicle for rear-axle toe. *BE40.20-P-1002-10E 
  Adjust     
1 Check vehicle level at front and rear axle with electronic inclination meter and adjust, if necessary   AR40.20-P-0301T 
2 Loosen bolt (60b) and bolt (60c)    
3 Adjust toe with the adjusting nut (60d) Overall toe-in at rear axle *BE40.20-P-1001-10E 
Permitted difference between right and left side of vehicle for rear-axle toe
IMPORTANT If test values are not achieved, replace tie rod, see: ↓
Remove/install track rod
*BE40.20-P-1002-10E 
Model 211 AR35.20-P-0109R
Model 219 AR35.20-P-0109TX
4 Tighten bolt (60b) and bolt (60c)    
Model 219
TORQUE SPECIFICATION
*BA35.20-P-1002-04E 
Model 211
TORQUE SPECIFICATION
*BA35.20-P-1002-04C 
INSPECTION VALUES FOR TOE-IN AT REAR AXLE

Number Designation Model 211.0/2 ECE/USA with 16" tires, except 4MATIC, model 211.6 ECE/USA with 16" tires Model 211.0/2 ECE/USA with 17" or larger tires, except 4MATIC, model 211.6 ECE/USA with 17" or larger tires
BE40.20-P-1001-10E Overall toe-in at rear axle ∠° 0° 20'(±7') 0° 20'(±7')
BE40.20-P-1002-10E Permissible difference in rear axle toe-in between right and left sides of the vehicle ∠° 7' 7'
INSPECTION VALUES FOR TOE-IN AT REAR AXLE

Number Designation Model 211.0/2 with 4MATIC and 16" tires Model 219 ECE/USA with 16" tires
BE40.20-P-1001-10E Overall toe-in at rear axle ∠° 0° 25'(±7') 0° 20'(±7')
BE40.20-P-1002-10E Permissible difference in rear axle toe-in between right and left sides of the vehicle ∠° 7' 7'
INSPECTION VALUES FOR TOE-IN AT REAR AXLE

Number Designation Model 219 ECE/USA with 17" tires or larger
BE40.20-P-1001-10E Overall toe-in at rear axle ∠° 0° 20'(±7')
BE40.20-P-1002-10E Permissible difference in rear axle toe-in between right and left sides of the vehicle ∠° 7'
TIE ROD

Number Designation Model 211
BA35.20-P-1002-04C Self-locking nut, track rod to rear axle carrier Nm 70
TIE ROD

Number Designation Model 219
BA35.20-P-1002-04E Self-locking nut, track rod to rear axle carrier Nm 70