Reworking body at front fenders - AZ40.10-P-0001-04T

Set the fender flange in several stages in the marked area (B).
Use a plastic mallet to avoid damaging paint.

Use a hot air blower to heat up the fender outer edges carefully to a maximum of 70 - 80°C

Do not overheat paint when heating up (maximum 80°C). Repair any damage to the paint.
Re-preserve wheel housing with underfloor protection and spray the repositioned fender edges with cavity preservation.

Fig 1: Identifying Front Fender Flange Marked Area
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.