Remove/install antenna - AR82.70-P-8951TM

MODEL 211.0 as of 1.6.06 except CODE (413) Panoramic sliding roof 

MODEL 211.0 as of 1.6.06 with CODE (494) USA version with CODE (413) Panoramic sliding roof 

MODEL 211.2 as of 1.6.06 

MODEL 219.3 as of 1.6.06 

Shown on model 211.0 with code (414) Power glass tilting/sliding roof and code (527) COMAND APS (with navigation) 

Fig 1: Identifying Roof Antenna, Adhesive Strip And Antenna Cables

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Lower rear head restraints
2.1	Detach headliner from roof paneling and, with electrical wiring harness connected, place down on the seats as far forward as possible	Model 211.0 with code (414) Power glass tilting/sliding sunroof.	AR68.30-P-4300TA
		Model 211.0 without code (414) Power glass tilting/sliding roof or without code (413) Panoramic sliding roof	AR68.30-P-4300T
		Model 211.2	AR68.30-P-4300TD
		Model 219.3	AR68.30-P-4300TY
2.2	Detach headliner at the rear and carefully pull down until roof antenna (A2/49) is accessible	Model 211.0 with CODE (413) Panoramic sliding sunroof and code (494) USA version.	AR68.30-P-4300TB
3	Expose antenna lines (2) and disconnect electrical connectors of antenna lines (2)	Quantity and type of fastening of antenna lines (2) can differ depending on model and vehicle equipment. Installation:  Observe color coding of electrical connectors.
4	Detach roof antenna (A2/49) from roof	The roof antenna (A2/49) must not be dismantled, since this will damage the roof antenna (A2/49). Installation:  Check seal of roof antenna (A2/49), replace if necessary and clean sealing surfaces.	*BA82.62-P-1001-01A
5	Install in the reverse order