Removing and installing rear air nozzle - AR83.10-P-4800T

MODEL 211.0/2/6 

Rear center air nozzle 

Fig 1: Identifying Rear Air Nozzle Components (1 Of 2)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Rear Air Nozzle Components (2 Of 2)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

MODIFICATION NOTES

16.12.03

Step added

Steps 1 to 5

	Remove/install
1	Actuate left release (10) and open lid on stowage box (4)
2	Remove inner lip from stowage box (4)
3	Lift up floor panel (11) and remove from stowage box (4)
4	Unclip rear wall (12) in stowage box (4) using a screwdriver (13) and set down to one side in the stowage box (4)
5	Unscrew bolt (14)
6	Move front passenger seat to front-most position	See Operating Instructions
7	Unclip stowage compartment (2) using mounting wedge (3) from stowage box (4) and place to one side with connected electrical line		Fig 3
8	Unscrew bolts (5)
9	Unlock detent hooks (6) and pull center air nozzle (1) out of the stowage box (4)	Release is effected by inserting a suitable screwdriver through the vent grille of the center air nozzle (1). Detent hooks (6) must audibly snap into place.
10	Unclip both levers (7) on the center air nozzle (1) (arrows)	Carefully unclip lever (7) as otherwise the lever (7) may break off.
11.1	Undo screws (9) and remove the air nozzle operating module (8) from the center air nozzle (1)	On vehicles without code (581b) convenience automatic air conditioning
11.2	Undo screws (9) and remove control panel rear switch group (S81) from center rear air nozzle (1)	On vehicles with code (581b) convenience automatic air conditioning
12	Install in the reverse order

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.