Programming of control units - AR54.21-P-0014Y

MODEL 129.058 /063 /067 /076, 163, 164, 168, 169, 170, 171, 199, 203, 204, 207, 208, 209, 210, 211, 212, 215, 216, 218, 219, 220, 221, 230, 240, 245, 251, 450, 452, 454, 461.302 /304 /305 /331 /332 /333 /334 /340 /342 /343 /344 /345 /346, 463.206 /208 /209 /232 /233 /240 /241 /243 /244 /245 /246 /247 /248 /249 /250 /254 /270 /271 /303 /306 /308 /309/322 /323 /332 /333 /336 /340 /341 /346 (except, 245.286) 

Offline-Programmierung mit Release-CD 

		It is important to ensure an adequate voltage supply for the on-board electrical system throughout the entire work procedure as the control units could be damaged if undervoltage occurs.
	Notes on programming control units		AH54.21-P-0001-03Y
1	Connect STAR DIAGNOSIS and start Diagnosis Assistance System (DAS)
	Connect STAR DIAGNOSIS and read out fault memory	Model 129, 163, 164, 168, 169, 170, 171, 199, 203, 204, 207, 208, 209, 210, 211, 212, 215, 216, 218, 219, 220, 221, 230, 240, 245, 251, 461, 463	AD00.00-P-2000-04A
		Model 450	AD00.00-P-2000-04SM
		Model 452	AD00.00-P-2000-04RR
		Model 454	AD00.00-P-2000-04FF
2	Program control unit		AR54.21-P-0014-01Y
3	Perform software calibration number (SCN) coding for control units	Only when required, refer to DAS.	AR54.21-P-0015X
4	Run coding program	Only when required, refer to DAS.
5	Read out and erase fault memory
6	Close STAR DIAGNOSIS