Remove/install panoramic roof rear roller sun blind couplings - AR77.21-P-0221T

MODEL 211.0 with CODE (413) Panoramic sliding roof

MODEL 211.0

with CODE (413) Panoramic sliding roof

with CODE (419) Solar module for panoramic roof

Shown on right side of vehicle

Fig 1: Identifying Panoramic Roof Rear Roller Sun Blind Couplings Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

MODIFICATION NOTES

25.7.06

Loosen headliner, do not remove

Step 2

	Remove/install
	Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof.	Keep body parts and limbs well clear of moving parts.	AS00.00-Z-0011-01A
1	Move panoramic roof to tilt position
2	Loosen headliner and lay down on head restraints with lines connected.		AR68.30-P-4300TB
3	Unclip terminal strip (6) simultaneously from left and right roller sun blind coupling (1) by turning in direction of arrow (arrow C).
4	Unscrew bolts (3, 4) on left and right side of front glass roof	Installation: Replace self-locking bolts (4).
5	Loosen bolt (5) on left and right side of front glass roof.
6	Pull down guide rail (2) in direction of arrow (arrow B).
7	Slide roller sun blind coupling (1) toward rear (arrow C) out of guide rail (2) and remove.	Observe installation position of roller sun blind coupling (1).
8	Install in the reverse order