Retrofit audio gateway control unit - AN82.61-P-0001-07TB
- Fasten audio gateway control unit (N93/1) onto bracket (2) using two nuts (5).
- Place fan (3) onto bracket (2) and fasten using two nuts (4).
- Connect black 14-pin coupling (6) from auto pilot system wiring harness (1) to audio gateway control unit (N93/1).
- Connect black 4-pin connector from auto pilot system wiring harness (1) to black 4-pin coupling (7) from fan wiring harness (3).
- Connect black 4-pin connector (8) from fan wiring harness (3) to audio gateway control unit (N93/1).
- Fasten auto pilot system wiring harness (1) using given cable strap holder (arrow) onto bracket (2).
- Fasten auto pilot system wiring harness (1) and fan wiring harness (3) as shown.
Make sure that both wiring harnesses are routed such that they do not chafe or make any noise.
The coupling (11) for the Media Oriented System Transport (MOST) fiber optic cable is connected at a later stage.
- Place bracket (2) with audio gateway control unit (N93/1) onto left rear wheel arch.
- Fasten bracket (2) using nut (9) and bolts (10).