LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2008 >> E350 Base >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Propeller Shaft -- E350 (211.256) >> Testing & Repair >> Press in guide sleeve - AR41.10-P-0200-03T

Press in guide sleeve - AR41.10-P-0200-03T

CHECK VALUES FOR PROPELLER SHAFT ALIGNMENT SLEEVE

Number Designation Model 211.004/007/061/065/261/265 Model 211.006/008/016/070/072/206/208/216/270/272 Model 211.023/223
BE41.10-P-1001-02L Insertion dimension "a" from face end of alignment sleeve to joint flange Front propeller shaft mm 23.3 24.8 24.8
Rear propeller shaft mm 26,3 28.3 28.3
See picture - - -
CHECK VALUES FOR PROPELLER SHAFT ALIGNMENT SLEEVE

Number Designation Model 211.026/028/029/226 Model 211.041/042/241/242
BE41.10-P-1001-02L Insertion dimension "a" from face end of alignment sleeve to joint flange Front propeller shaft mm 25.3 23.3
Rear propeller shaft mm 28.8 26.8
See picture - -
CHECK VALUES FOR PROPELLER SHAFT ALIGNMENT SLEEVE

Number Designation Model 211.020/220 with transmission 716.6 Model 211.020/022/220/222 with transmission 722.902
BE41.10-P-1001-02L Insertion dimension "a" from face end of alignment sleeve to joint flange Front propeller shaft mm 24.8 25.3
Rear propeller shaft mm 28.3 28.8
See picture - -
CHECK VALUES FOR PROPELLER SHAFT ALIGNMENT SLEEVE

Number Designation Model 211.056/256 Model 211.076/077/276/277 Model 211.08/09/28/29 except model 211.083/283
BE41.10-P-1001-02L Insertion dimension "a" from face end of alignment sleeve to joint flange Front propeller shaft mm 24.8 28.8 23.3
Rear propeller shaft mm 28.3 28.8 26.8
See picture - - -
CHECK VALUES FOR PROPELLER SHAFT ALIGNMENT SLEEVE

Number Designation Model 211.083/283 Model 211.606/616/620
BE41.10-P-1001-02L Insertion dimension "a" from face end of alignment sleeve to joint flange Front propeller shaft mm 25.3 24.8
Rear propeller shaft mm 28.8 28.3
See picture - -
  1. Use a suitable drift to drive in the new guide sleeve.

    IMPORTANT Observe press-in dimension (a) from the end face of the centering sleeve to the joint flange.

    IMPORTANT Depending on the version of flexible disk (for example, on vehicles with vibration damper) it may lead to a deviation between the measured and the specified press-in dimension "a". In this case the measured press-in dimension (a) is to be taken into account before removal.

    Fig 1: Installing Guide Sleeve
    G07078848Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
    Fig 2: Identifying Press-In-Dimension Of Centering Sleeve
    G07284314Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals