Align windshield in body opening - AR67.10-P-1000-04T
CHECK VALUES FOR WINDSHIELD
| Number |
Designation |
Model 211 without code 413, 419 |
Model 211 with code 413, 419 |
| BE67.10-P-1001-01C |
Distance between edge of sprayed area at windshield and front edge of roof |
mm |
2 |
- |
| BE67.10-P-1002-01C |
Distance between top edge of window and base center point of clip attaching trim strip at top |
mm |
- |
4.5 |
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
- Before applying glue bead position windshield (1) on windshield rubber spacers.
- Center windshield (1).
On vehicles with code (413) Panoramic sliding roof or with code (419) Solar module for panoramic roof, adjust distance between top edge of roof and base center point on mounting clip (2) on upper trim strip (a), center at side and fix in place with adhesive strips.
On vehicles without code (413) Panoramic sliding roof or without code (419) Solar module for panoramic roof, completely move windshield (1) with rubber lip to front edge of roof, center at side and fix in place with adhesive strips (distance results from rubber lip).
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
- Glue on strips of adhesive tape (arrows).
- Cut through adhesive strips (arrows) at edges of windshield (1).
Do not damage rubber channel beneath, do not remove adhesive strips (arrows).
- Remove windshield (1) from vehicle.