Perform version coding subsequently - AN82.61-P-0001-05TB
The described STAR DIAGNOSIS menu guidance corresponds to the German DAS version 05/2004 and may deviate from other versions.
- Connect STAR DIAGNOSIS to data link connector (X11/4).
- Start DAS, enter vehicle model and select the "Control units" menu item.
- In the "Control unit groups" menu, select the subgroups
- "Information and communication"
- "Audio, video, navigation and telematics"
- "AGW audio gateway"
- "Retrofitting MOST components"
one after the other.
- In the "Retrofitting MOST components" menu, perform the listed program run and transfer the new MOST ring sequence into the control unit.
- Go from the "Retrofitting MOST components" menu back to the "Information and communication" menu and select the subgroups
- "IC instrument cluster"
- "Control unit adaptations"
- "Variant coding"
- "Special equipment"
one after the other.
- In the "Special equipment" menu change the "Navigation" menu item from "not available" to "available" and transfer the coding into the control unit.
- Go from the "Special equipment" menu back to the "Control unit groups" menu and select the subgroups
- "Body"
- "System diagnosis"
- "Control unit adaptation"
- "Read coding and change if necessary"
- "Specified configuration of interior CAN bus"
one after the other.
- In the "Specified configuration of interior CAN bus" menu, check status of installed equipment, correct if necessary and transfer into control unit.
- Go from "Specified configuration interior CAN bus" menu back to the "Control unit adaptations" menu and select the subgroup "Knowledge base configuration".
- In the "Knowledge base configuration" menu, activate the "Self configuration" menu item.
- After completing the "Self configuration", go from the "Knowledge base configuration" menu back to the "Main groups" menu, run a quick test and delete the complete fault memory.
- End the DAS and disconnect STAR DIAGNOSIS