Remove/install main audio components - AR82.60-P-7605TA

MODEL 211.2/6 up to 1.6.08 except CODE (809) Model year 2009

Shown on model 211.2 with code (890) EASY-PACK liftgate

Fig 1: Identifying Main Audio Components

G07274954

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1.1	Remove left interior trim from side of load compartment	Model 211.2	AR68.30-P-1180T
1.2	Remove existing paneling on left side of load compartment until the audio gateway control unit (N93/1) is accessible	Model 211.6 Whether paneling exists or what paneling version is used depends on the vehicle equipment.
2	Remove left side trim in rear passenger compartment	With model 211.2 with code (890) EASY-PACK liftgate	AR68.30-P-4780T
3	Unscrew nuts (1)
4	Remove hydraulic unit housing (2) and place to one side	With model 211.2 with code (890) EASY-PACK liftgate
5	Disconnect electric connectors (3) from audio gateway control unit (N93/1)
6	Disconnect fiber optic cable connector (4) from audio gateway control unit (N93/1)	To avoid damaging the fiber optic cable, do not kink fiber optic cable, route over sharp edges or bend in radii smaller than 25 mm.
7	Cover fiber optic cable		AR82.95-P-0005-01A
8	Unscrew nut (5)
9	Slide bracket (6) with audio gateway control unit (N93/1) backwards until the nuts (7) are accessible
10	Unscrew nuts (7)
11	Push bracket (6) to one side and slide the audio gateway control unit (N93/1) backwards until the electrical connectors (8) are accessible
12	Disconnect electric connectors (8) from audio gateway control unit (N93/1)
13	Remove audio gateway control unit (N93/1) from side wall towards the rear
14	Install in the reverse order