Routing and connecting wiring harness - AZ54.65-P-0001-06TT

Prepare parking assist wiring harness (25) as shown in the diagram and route in the vehicle.

Fig 1: Routing Parking Assist Wiring Harness
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Connect parking assist wiring harness (25) to socket 17 (arrow) in rear SAM control module with fuse and relay module (N10/2) in left side of trunk.
Connect parking assist wiring harness (25) to rear bumper PTS connector (X35/28).

Fig 2: Locating Parking Assist Wiring Harness Connecting Socket
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Route parking assist wiring harness (25) along the left side wall as shown in the diagram to the overhead control and frame floor system connector (X25/8) and connect warning element wiring harness (22).
Fasten wiring harnesses with cable straps.

Fig 3: Identifying Parking Assist Wiring Harness, Frame Floor System Connector And Warning Element Wiring Harness
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Route parking assist wiring harness (25) in left-hand cable duct to the area of the left A-pillar.
Unclip left voltage distributor (CAN) connector (X30/7) from cable duct and unlock.
Connect branch-off line from parking assist wiring harness (25) to left voltage distributor (CAN) connector (X30/7).
Lock voltage distributor and clip into cable duct.

Fig 4: Identifying Parking Assist Wiring Harness And Voltage Distributor Connector
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.