Remove/install paneling on C-pillar - AR68.30-P-4490TX

MODEL 219.3 

Fig 1: Identifying Paneling On C-Pillar Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove
1	Remove rear seat backrest		AR91.12-P-1620TX
2	Press edge guard (2) to side in area of C-pillar paneling (1)
3	Pull C-pillar paneling (1) toward front, slightly tilt in direction of center of vehicle and remove from C-pillar toward front
4	Remove belt guide (3) from paneling Unclip C-pillar (1)
5	Remove seat belt (4) from paneling Remove C-pillar (1)
	Install
6	Remove sheet metal nut (5) and clip (6) from C-pillar mounts and insert into C-pillar paneling (1)	Sheet metal nut (5) and clip (6) remain in C-pillar mounts when removing C-pillar paneling (1).
7	Pull seat belt (4) in paneling in C-pillar paneling	Do not twist seat belt (4)
8	Clip belt guide (3) into C-pillar paneling (1)
9	Insert C-pillar paneling (1) with guides (arrows) into rear shelf	Hold C-pillar paneling (1) tilted slightly in direction of center of vehicle
10	Clip C-pillar paneling (1) to C-pillar	C-pillar paneling (1) fit can be adapted by pressing the sheet metal nut (5) into the mount.
11	Install rear seat backrest		AR91.12-P-1620TX