Retrofit portable CTEL mount for hands-free system - AZ82.70-P-0005-01QQT

Fig 1: Identifying Fastening Hook And Telephone Console With PSC Adapter

1. Position fastening hook (10) of telephone console with PSC adapter (1) as shown to covering (14) of AAC [KLA] control and operating unit so that the cutout in the telephone console with PSC adapter (1) is located above the chrome strip on the covering (14) (see arrow).
   Fig 2: Locating PSC Adapter

   
2. Install covering with AAC [KLA] control and operating unit and telephone console with PSC adapter (1) as shown to the center console.
3. Fasten telephone console with PSC adapter (1) as shown using the sheet metal screw (15) included in the parts scope in the separation line from the plastic to the carpet at the center console.
4. Route connecting cable (11) of telephone console with PSC adapter (1) as shown into the front passenger footwell and fasten in area of center tunnel with self-adhesive felt (see arrows).
5. Connect telephone console coupling (12) to interface FSE11 (3).
6. Fasten connecting cable (11) in the area of the vehicle's onboard wiring harnesses with the vehicle's on-board wiring harnesses so that they do not scuff or rattle.
   Fig 3: Locating PSC Adapter, Sheet Metal Screw And Connecting Cable

   
7. Route antenna line coupling (13) into center console and connect with plug for the antenna line VDA preinstallation (23).
8. Tie back excess length of antenna line in center console and fasten in place with vehicle's on-board wiring harnesses so that they will not scuff or rattle.
   Fig 4: Identifying Antenna Line Coupling And VDA Preinstallation