Attaching Mercedes-Benz quick-clamping devices - AR40.20-P-0230I

WARNING: This page is about a different car, the 2009 Mercedes-Benz E550 and 2008 Mercedes-Benz E550. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 209, 211, 215, 219, 220, 230, 240

Shows model 220

Fig 1: Attaching Mercedes-Benz Quick-Clamping Devices (1 Of 2)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Attaching Mercedes-Benz Quick-Clamping Devices (2 Of 2)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Installing, removing
1	Attach quick-clamping devices to front and rear axles and remove clamp handles	The mounting bell is centered on the front wheel hub or rear axle shaft flange by locating the tracer pins in the five mounting holes (arrows) in the rim. Check quick-clamping devices, wheel mirrors and measurement sensors at regular intervals in accordance with the manufacturer's instructions
		Quick-clamping device	*124589013100
2	Attach wheel mirrors or measurement sensors
3	Remove in reverse order

Fig 3: Identifying Quick Clamping Device (124 589 01 31 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.