Wiring diagram for telephone (TEL) control unit - PE82.70-P-2101-99CAA
MODEL 216.3 with CODE (386) Preinstallation for cell phone, UPCI system with CODE (389) Mobile phone preinstallation with universal interface, USA/Canada up to model year 2010 /YoM 09, control unit N123/1
| Code | Designation | Location |
|---|---|---|
| A0 | Explanation of color codes | 32L |
| A2/49 | Telephone and GPS antenna | 14L |
| A2/49a1 | CTEL antenna | 14L |
| A28/2x1 | Portable CTEL antenna amplifier connector | 6L |
| A28/3 | E-net compensator | 9L |
| A34/15 | UHI portable CTEL holder (Universal Handy Interface) | 19L |
| A34/15x1 | Connector 1, UPCI [UHI] portable CTEL holder (Universal Handy Interface) | 18J |
| A34/15x2 | Connector 2, UPCI [UHI] portable CTEL holder (Universal Handy Interface) | 16J |
| A67b1 | Hands-free system microphone group | 26L |
| A67b1x1 | Hands-free system microphone group connector | 24H |
| N10/2 | Rear SAM control unit with fuse and relay module | 3L |
| N123/1 | Universal Portable CTEL Interface (UPCI [UHI]) control module | 4A |
| N123/1 | Universal Portable CTEL Interface (UPCI [UHI]) control module | 12A |
| N123/1 | Universal Portable CTEL Interface (UPCI [UHI]) control module | 20A |
| N123/1 | Universal Portable CTEL Interface (UPCI [UHI]) control module | 29A |
| U1 | Valid for {{USA}} | 5F |
| U1 | Valid for {{USA}} | 12F |
| U20 | Valid for all except {{USA}} {{Japan}} | 7F |
| U434 | Not valid for VCS [SBS] | 24C |
| U904 | Wiring harness installed but nonfunctional | 5F |
| W6 | Ground (left wheelhousing in trunk) | 8C |
| X25/8 | Overhead control panel and FFS [RBA] connector | 25E |
| X39/37 | CTEL separation point | 19E |
| X39/39 | Handy connector | 16H |
| X39/39 | Handy connector | 16E |
| X39/48 | Breakdown assistance/info button connector | 17G |
| Z20/30 | Tracer wire connector sleeve | 19H |
| Z6/56 | Circuit 31 connector sleeve | 7E |
| Z7/40 | Circuit 30 connector sleeve | 2E |