| 1 |
Remove padding (2) from left or right front seat backrest |
|
AR91.10-P-1090SC |
| 2 |
Unhook cover (1) from hooks (3) |
|
|
| 3 |
Open Velcro fasteners (arrows) |
|
|
| 4 |
Slip cover (1) over upholstery (2) |
 Installation:
Check seating of cover (1), adjust if necessary. |
|
| 5 |
Unhook staple wires in staple wire pockets (11) from staple clips (5) using a suitable tool |
The two staple wires in the staple wire pockets (11) are fastened with 3 staple clips (5) each. The position of staple clips (5) in padding (2) can be recognized with the aid of the X markings located on cover (1).
Installation:
To reduce the amount of wrinkles, match up the X markings located on cover (1) with the corresponding staple clips (5). |
|
| 6 |
Pull staple wires out of staple wire pockets (11) |
|
|
| 7 |
Unhook staple wire in staple wire pocket (9) from staple clips (6) using a suitable tool |
The staple wire in staple wire pocket (9) is fastened with 4 staple clips (6). The position of staple clips (6) in padding (2) can be recognized with the aid of the X markings located on cover (1).
Installation:
To reduce the amount of wrinkles, match up the X markings located on cover (1) with the corresponding staple clips (6). |
|
| 8 |
Pull staple wire out of staple wire pocket (9) |
|
|
| 9 |
Unhook staple wire in staple wire pocket (10) from staple clips (7) using a suitable tool |
The staple wire in the staple wire pocket (10) is fastened with 3 staple clips (7). The position of staple clips (7) in padding (2) can be recognized with the aid of the X markings located on the cover (1).
Installation:
To reduce the amount of wrinkles, match up the X markings located on cover (1) with the corresponding staple clips (7). |
|
| 10 |
Pull staple wire out of staple wire pocket (10) |
|
|
| 11 |
Remove the upholstery (1). |
Installation:
Guide sidebag unit pocket (4) through opening (8) in padding (2). |
|
| 12 |
Install in the reverse order |
|
|