Testing and repair work: Passenger cars: Rear axle - AR35.00-Z-9216AA
MODEL 216
| Constant-velocity joint or rubber boot on rear halfshaft - removal and installation | MODEL 166, 170, 171, 172, 203, 204, 207, 208, 209, 211, 212, 215, 216, 218, 219, 220, 221, 230... | see AR35.30-P-0661P |
| Front rubber mount of rear axle mount - Removal and installation | MODEL 221 except CODE (Z07) Top protection MODEL 216 | see AR35.10-P-0041SX |
| Lower rear axle. | MODEL 221, 216 | see AR35.10-P-0015SX |
| Rear rubber bushing, rear axle mount - Removal and installation | MODEL 221 except CODE (Z07) Top protection MODEL 216 | see AR35.10-P-0042SX |
| Remove/install camber strut | MODEL 221, 216 | see AR35.20-P-0110SX |
| Remove/install complete rear axle | MODEL 221, 216 | see AR35.10-P-0010SX |
| Remove/install differential | MODEL 216, 221... | see AR35.31-P-0520SX |
| Remove/install differential | MODEL 216, 221... | AR35.31-P-0520SZ |
| Remove/install end cover at differential | MODEL 216, 221... | see AR35.31-P-0554SX |
| Remove/install end cover at differential | MODEL 216, 221... | AR35.31-P-0554SZ |
| Remove/install front differential mount on rear axle carrier | MODEL 216, 221... | see AR35.10-P-0051SX |
| Remove/install front differential mount on rear axle carrier | MODEL 216, 221... | AR35.10-P-0051SZ |
| Remove/install radius rod | MODEL 221, 216 | see AR35.20-P-0111SX |
| Remove/install rear axle shaft | MODEL 221 With inserted rear axle shafts MODEL 216 | see AR35.30-P-0620SX |
| Remove/install rear axle shaft flange and angular ball bearing | MODEL 216 (except 216.379) MODEL 221 (except 221.179) MODEL 221 | see AR35.20-P-0130SX |
| Remove/install rear axle shaft flange and angular ball bearing | MODEL 216.379 MODEL 221.179 MODEL 221 with CODE (Z07) maximum protection | AR35.20-P-0130SXA |
| Remove/install rear rubber bushings for differential mount in rear axle carrier | MODEL 216, 221... | see AR35.10-P-0050SX |
| Remove/install rear rubber bushings for differential mount in rear axle carrier | MODEL 216, 221... | AR35.10-P-0050SZ |
| Remove/install spring control arm and replacement of rubber mount | MODEL 221 MODEL 216 | see AR35.20-P-0114SX |
| Remove/install supporting joint at wheel carrier (wheel carrier installed) | MODEL 221 except CODE (Z07) Top protection MODEL 216 | see AR35.20-P-0116SX |
| Remove/install thrust arm | MODEL 221, 216 | see AR35.20-P-0113SX |
| Remove/install track rod | MODEL 221, 216 | see AR35.20-P-0109SX |
| Remove/install wheel carrier | MODEL 216 MODEL 221 | see AR35.20-P-0115SX |
| Replace radial sealing rings on side of rear axle center assembly | MODEL 221 With inserted rear axle shafts MODEL 216 | see AR35.31-P-0545SX |