Install support ring on damper - AR32.25-P-1018-01TS
WARNING: This page is about a different car, the 2011 Mercedes-Benz C300, 2010 Mercedes-Benz C300, 2009 Mercedes-Benz C300, and 2008 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.
The support washer (3c), contact rubber (3d) and spring cup (3e) must be mounted on the shock absorber (2).
- Measure the dimension (M) from the center of the bore on the lower fork up to the spring support surface on the spring cup (3e) on the old shock absorber (2).
- Install support ring (3a) on new shock absorber (2) with dimension identical to measured dimension (M) on old shock absorber (2).
Do not overstretch support ring (3a).