Disposing of shock absorber - OS32.25-P-0121-01GC
WARNING: This page is about a different car, the 2011 Mercedes-Benz C300, 2010 Mercedes-Benz C300, 2009 Mercedes-Benz C300, and 2008 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.
- Drill a hole in the shock absorber tube approx. 45 mm (dimension A) away from the bottom eyelet using a 5 mm dia. drill bit (the gas escapes).
- Push piston rod all the way in and pull out again.
- Remove protective tube from shock absorber.
- Drill a hole in the shock absorber tube approx. 30 mm (dimension B) away from the top edge of the tube using a 5 mm dia. drill bit.
- Pump the shock absorber empty by pushing in and pulling out the piston rod several times.
Observe regulations governing disposal of hydraulic fluid.
- Dispose of shock absorber (scrap).