Notes on measuring tire tread depth - AH40.10-P-0006-01T
WARNING: This page is about a different car, the 2011 Mercedes-Benz C300, 2010 Mercedes-Benz C300, 2009 Mercedes-Benz C300, and 2008 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.
All models
The brake pad check gauge (1) is suitable for measuring:
- Tire tread depth
- Brake lining thickness of outer brake pads (not all models)
The printed-on symbols and arrows identify that side of the brake pad check gauge (1) which is to be used for the corresponding measurement.
Information for measuring tire tread depth:
Before each measurement, move the slide (2) so that it touches the driver (3) otherwise the measurement may be incorrect.
Mount the brake pad check gauge (1) on two tread blocks at the point of maximum tire wear.
Push the feeler gauge (4) into the tread groove until it touches the groove bottom.
The measuring drift (4) must not contact the wear marking.
Remove brake pad check gauge (1) for reading off the measured value.