Remove/install drive cable for panoramic sliding roof - AR77.21-P-0240CW

WARNING: This page is about a different car, the 2011 Mercedes-Benz C300, 2010 Mercedes-Benz C300, 2009 Mercedes-Benz C300, and 2008 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 204.0/2/9 with CODE (413) Panoramic sliding roof

Shown on model 204.0, on right drive cable (1)

Fig 1: Removing Panoramic Sliding Roof Drive Cable

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove left and right drive slider		AR77.21-P-0510CW
2.1	Detach headliner and lay down on seats	Model 204.0	AR68.30-P-4300CW
2.2	Remove headliner	Model 204.2	AR68.30-P-4300CX
2.2	Remove headliner	Model 204.9	AR68.30-P-4300CY
3	Remove panoramic sliding roof control unit from panoramic roof (2) and allow to hang down with electrical lines connected		AR77.21-P-6995CW
4	Slide left and right drive cable (1) out of corresponding guide rail (4) with screwdriver (3) toward rear in front area of guide rails (4)	Always replace drive cable (1) in pairs. Installation: Completely push both drive cables (1) into guide rails (4) toward front to stop with aid of an old drive cable (1).
5	Install in the reverse order