Internet mode (i-mode™) function - GF82.70-P-2016CWJ
MODEL 204.0 /2 with CODE (498) Japan version up to Model Year 8 Code Division Multiple Access (CDMA) bzw. Freedom of Mobile Multimedia Access (FOMA)
Function requirements
- Status "circuit 30 ON" or "circuit 15R ON"
- Mobile phone and COMAND controller unit (A40/3) are switched on
- Mobile phone system operating error-free
- A mobile telephone network is available in adequate strength and quality
- Mobile phone electrical connector (X39/37) is connected to communication control unit (N123/6)
- Compatible mobile phone is connected to pre-installed connector or Bluetooth-compatible mobile phone in the vehicle and logged on to the COMAND controller unit
- The following provider settings have been completed:
- Connection name, dial-in number, telephone name
- DNS server 1 and 2, proxy server, port number, APN
- Time limit, data communication, mail account
- Mail password, mail address, user, homepage
- Post Office Protocol 3 (POP3) server (for receiving emails)
- Simple Mail Transfer Protocol (SMTP) server (for transmitting emails)
The function is described with a mobile phone attached to the connector. Any differences with a mobile phone not attached to the connector and one operated using Bluetooth are described as information points in each respective subfunction.
General
The mobile phone enables the user to access the Internet. To be able to use the Internet Mode (i-mode) function which is widespread in Japan, the mobile phone also has to support the i-mode data exchange event log (DoCoMo i-Navi Link mobile phone).
The Internet application enables the user to access the Internet. The Internet Mode (i-mode) function contains the "Run Internet application and establish Internet connection" subfunction.
Operating instructions
Using the Internet is only possible via the Audio/COMAND control panel (A40/9) and the Audio/COMAND display (A40/8).
Run Internet application and establish Internet connection function sequence
The Internet application in the "ComTEL/telephone" menu item is selected using the "TEL" phone button on the COMAND controller unit and the Audio/COMAND control panel on the Audio/COMAND display.
The control signals from the COMAND controller unit telephone buttons are processed internally. The control signals from the Audio/COMAND control panel are forwarded over the telematics CAN to the COMAND controller unit. The menu item is shown on the Audio/COMAND display by the COMAND controller unit over a low voltage differential signaling (LVDS) line.
The connection to the Internet is set up by the COMAND controller unit in the following way:
- Discrete line
- Communication control unit
- Discrete line
- Plug connection
- Discrete line
- Multifunction antenna (A28/11)
A browser is integrated into the COMAND controller unit for showing the websites on the Audio/COMAND display. The data for showing websites is sent by the COMAND controller unit via a LVDS line to the Audio/COMAND display.
On a mobile phone not connected to the connector and operated via Bluetooth, the connection to the Internet is set up by the COMAND controller unit in the following way:
- Discrete line
- Bluetooth antenna (A2/91)
- Mobile phone antenna
| Electrical function diagram for phone, email, Internet | PE82.70-P-2057-99FAA | ||
| Front central operating unit, component description | A40/9 | GF54.21-P-4500CW | |
| Cockpit central display, component description | A40/8 High |
GF54.30-P-6100CWH | |
| Telephone and GPS roof antenna component description | A28/11 | GF82.62-P-4119CW | |
| Bluetooth antenna component description | A2/91 | GF82.62-P-4201CW | |
| Communication control unit, component description | N123/6 | GF82.70-P-5003CWJ | |
| Mobile phone interface, component description | X39/37 | GF82.70-P-5004CWJ | |
| COMAND controller unit, component description | A40/3 | GF82.85-P-3136CWJ |